The larger range of AJM EnviroSEP-L™ units are available in capacities ranging 5kl/hr upwards. All AJM EnviroSEP-L™ units are fabricated in stainless steel with a stainless steel plate pack.

Designed and manufactured in Australia, the EnviroSEP-L™ is suitable for a variety of applications including full flow run off or first flush treatment of stormwater from contaminated yards, car parks, wash bays and any other areas where oil contamination is possible.

The units are designed to remove free oils and grease to very low levels (<10ppm), which is adequate to comply with most current legislations.
 

The key to the EnviroSEP-L™ design is it' simplicity.

Contaminated water is pumped automatically or gravity flows to the EnviroSEP-L™ inlet where leaves, twigs and other foreign objects are removed from the water by a large volume removable basket strainer.

The water then flows though the multistage coalescing media where oil droplets and smaller particles are separated from the water phase. As the oil layer builds up on the surface of the unit it overflows into a built-in oil tank. The treated water passes over an adjustable weir and can be discharged directly into storm water drains.

The EnviroSEP-L™ can be fitted with a major spill protection cut off security system which, following a major spillage automatically stops the pump within a matter of minutes. This feature prevents the possibility of large quantities of oil discharging to drain.

All AJM engineering for the EnviroSep is carried out using the latest AutoCAD software.
 

AN ENVIROSEP™ WILL ALWAYS...